Home › Engine / Hybrid System › 2AR-FE STARTING › IGNITION SWITCH
RM30B0U _51 Engine / Hybrid System _010840 2AR-FE STARTING _0057908 IGNITION SWITCH G

2AR-FE STARTING  IGNITION SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT IGNITION SWITCH ASSEMBLY

a.
A296191
2.188,1.271 2.656,1.438 true 1.51,1.302 1.281,1.781 true 1.917,1.021 2.469,0.531 true 1.51,1.031 1.177,0.51 true 1.229,1.271 0.813,1.49 true 1.927,1.302 2.177,1.729 true 1.219,1.052 0.802,0.896 true 0.042,0.042 0.354,0.198 0.313,0.156 10 *a 2.74,1.375 3.177,1.573 0.438,0.198 10 AM1 1.083,1.823 1.521,2.021 0.438,0.198 10 ACC 2.583,0.427 3.021,0.625 0.438,0.198 10 ST2 0.865,0.344 1.302,0.542 0.438,0.198 10 IG2 0.5,1.385 0.938,1.583 0.438,0.198 10 IG1 2.104,1.802 2.542,2 0.438,0.198 10 ST1 0.448,0.823 0.885,1.021 0.438,0.198 10 AM2
*a Component without harness connected
(Ignition Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
All combinations of all terminals LOCK 10 kΩ or higher
5 (AM1) - 7 (ACC) ACC Below 1 Ω
5 (AM1) - 7 (ACC)
5 (AM1) - 8 (IG1)
4 (AM2) - 3 (IG2)
ON Below 1 Ω
6 (ST1) - 5 (AM1)
6 (ST1) - 8 (IG1)
2 (ST2) - 4 (AM2)
2 (ST2) - 3 (IG2)
START Below 1 Ω


If the result is not as specified, replace the ignition switch assembly.