When the ECM detects a cruise control switch signal, it sends it to the combination meter assembly through CAN communication. Then the cruise control indicator light turns on.
The cruise control indicator light circuit uses CAN communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.
Select the Active Test, use the Techstream to generate a control command, and then check that the cruise control indicator light illuminates.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Indicat. Lamp Cruise | Cruise control indicator light | ON or OFF | - |
| Tester Display |
|---|
| Indicat. Lamp Cruise |
| Proceed to |
|---|
| Cruise control indicator light turns ON/OFF |
| Cruise control indicator light does not turn ON/OFF |
Cruise control indicator light turns ON/OFF
Cruise control indicator light does not turn ON/OFF
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check the Data List for proper functioning of the cruise control indicator light.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| CCS Indicator M-CPU | Cruise control indicator (Main CPU) | ON or OFF | ON: Cruise control switch on, cruise control indicator light on
OFF: Cruise control switch off, cruise control indicator light off |
- |
| Tester Display |
|---|
| CCS Indicator M-CPU |
When the cruise control switch operation is performed, the result will be the same as above.
| Proceed to |
|---|
| OK |
| NG |
OK
NG