Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM
RM30B0U _51 Engine / Hybrid System _010069 CRUISE CONTROL _0057920 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Cruise SET Indicator Light Circuit  


DESCRIPTION

·

When the ECM detects a cruise control switch on signal from the cruise control switch, it sends it to the combination meter assembly through CAN communication. Then the cruise control SET indicator light turns on.

·

The cruise control SET indicator light circuit uses CAN communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.


PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM
a.

Select the Active Test, use the Techstream to generate a control command, and then check that the cruise control SET indicator light illuminates.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Indicat. SET Cruise control SET indicator light ON or OFF -
Body Electrical > Combination Meter > Active Test
Tester Display
Indicat. SET
50004 122 91

Result:
Proceed to
Cruise control SET indicator light turns ON/OFF
Cruise control SET indicator light does not turn ON/OFF



Cruise control SET indicator light turns ON/OFF

2.READ VALUE USING TECHSTREAM

Cruise control SET indicator light does not turn ON/OFF

2.READ VALUE USING TECHSTREAM
a.

Check the Data List for proper functioning of the cruise control SET indicator light.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST

Powertrain > Cruise Control > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
SET/COAST Switch -SET switch ON or OFF ON: -SET switch is on
OFF: -SET switch is off
-
Powertrain > Cruise Control > Data List
Tester Display
SET/COAST Switch
50003 76 21
OK:

On Techstream screen, item changes between ON and OFF according to above chart.



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG