Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE FLUID
RM30B0U _54 Brake _010843 BRAKE SYSTEM (OTHER) _0057925 BRAKE FLUID A

BRAKE SYSTEM (OTHER)  BRAKE FLUID  REPLACEMENT  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform brake fluid replacement with the shift lever in P and the parking brake applied.

·

As brake fluid may overflow, do not leave the brake fluid can in the reservoir filler opening when adding brake fluid.

·

Do not allow brake fluid to come into contact with any painted surface. If contact occurs, wash off the fluid immediately.

·

Perform brake fluid replacement while adding fluid to maintain the fluid level between the MIN and MAX lines of the reservoir.



PROCEDURE

Hide 1.REMOVE COWL TOP VENTILATOR LOUVER BRACKET LH

a.
C278578

Detach the 5 claws and remove the cowl top ventilator louver bracket LH.


Hide 2.REPLACE BRAKE FLUID

a.

Remove the brake master cylinder reservoir filler cap assembly.


b.

Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brakes.

Brake fluid:

SAE J1703 or FMVSS No. 116 DOT 3


NOTICE:

Do not remove the filter from the brake master cylinder reservoir and be sure to fill with new brake fluid to avoid any potential contamination of the brake system. Contamination, for example by dirt particles or mineral oil, could lead to functional brake problems.



c.

Loosen the bleeder plug of the front disc brake cylinder RH.


d.

Repeatedly depress the brake pedal and bleed the air from the bleeder plug of the front disc brake cylinder RH.

NOTICE:

Add fluid as necessary so that the fluid in the reservoir does not decrease below the MIN level.



e.

After air is completely bled out, tighten the bleeder plug while depressing the brake pedal.

Torque:
8.3 N*m (85 kgf*cm, 73 in.*lbf)


f.

Bleed the air from the bleeder plug of the front disc brake cylinder LH using the same procedure as for the RH side.


g.

Loosen the bleeder plug of the rear disc brake cylinder RH.


h.

Repeatedly depress the brake pedal and bleed the air from the bleeder plug of the rear disc brake cylinder RH.

NOTICE:

Add fluid as necessary so that the fluid in the reservoir does not decrease below the MIN level.



i.

After air is completely bled out, tighten the bleeder plug while depressing the brake pedal.

Torque:
8.3 N*m (85 kgf*cm, 73 in.*lbf)


j.

Bleed the air from the bleeder plug of the rear disc brake cylinder LH using the same procedure as for the RH side.


k.

Check for brake fluid leaks.


l.

Check the brake fluid level in the reservoir (Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID>ON-VEHICLE INSPECTION).


Hide 3.INSTALL COWL TOP VENTILATOR LOUVER BRACKET LH

a.

Attach the 5 claws to install the cowl top ventilator louver bracket LH.