Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER
RM30B0U _54 Brake _010843 BRAKE SYSTEM (OTHER) _0057927 BRAKE MASTER CYLINDER A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure the tip of the master cylinder points downward when handling the master cylinder.

·

Make sure foreign matter does not adhere to the piston of the master cylinder. If foreign matter adheres, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.



PROCEDURE

Hide 1.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 2.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 3.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

C211024
2.458,0.802 2.573,0.948 0.115,0.146 10 false A 2.208,1.667 2.375,1.906 0.167,0.24 10 false B 1.927,0.917 2.094,1.125 0.167,0.208 10 false B

a.

Release the vacuum pressure in the brake booster as follows.

i.

Stop the engine.


ii.

Depress the brake pedal several times.



b.

Disconnect the brake fluid level warning switch connector labeled A.


c.

Using a union nut wrench, disconnect the 2 brake lines labeled B from the brake master cylinder.


d.

Remove the 2 nuts.


e.
C211023

Pull out the brake master cylinder from the brake booster.

NOTICE:
·

The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure the tip of the master cylinder points downward when handling the master cylinder.

·

Make sure foreign matter does not adhere to the piston of the master cylinder. If foreign matter adheres, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.




f.

Remove the O-ring from the brake master cylinder.