Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM30B0U _54 Brake _010844 BRAKE (FRONT) _0057930 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.TEMPORARILY INSTALL FRONT DISC BRAKE BLEEDER PLUG

a.

Temporarily install the front disc brake bleeder plug to the disc brake cylinder.

HINT:

The front disc brake bleeder plug will be tightened to a torque specification in the "Bleed Brake Line" procedures.



Hide 2.INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP

Hide 3.INSTALL PISTON SEAL

a.
C191865
0.795,2.915 0.948,3.064 0.153,0.149 10 *1
*1 Lithium soap base glycol grease


Apply a light coat of lithium soap base glycol grease to the entire inner and outer circumference of a new piston seal.


b.

Install the piston seal to the disc brake cylinder.

NOTICE:

Securely install the piston seal into the groove of the disc brake cylinder.



Hide 4.INSTALL FRONT DISC BRAKE PISTON

a.
C194711
0.745,2.87 0.967,3.057 0.222,0.187 10 *1
*1 Lithium soap base glycol grease


Apply a light coat of lithium soap base glycol grease to the inner and outer circumference of a new cylinder boot, as well as the entire circumference of the top and bottom of the outer edge as shown in the illustration.


b.

Apply a light coat of lithium soap base glycol grease to the entire outer circumference of the front disc brake piston where it contacts the cylinder boot and disc brake cylinder.


c.

Install the cylinder boot to the front disc brake piston.


Hide 5.INSTALL CYLINDER BOOT

a.
C194712
0.758,0.498 0.909,0.645 0.152,0.147 10 *2 1.032,0.096 1.193,0.243 0.161,0.147 10 *1 1.648,0.388 1.648,0.19 1.648,0.19 1.224,0.19 false 1.506,0.61 0.935,0.61 false 0.626,0.82 0.787,0.967 0.161,0.147 10 *3 1.437,0.843 0.94,0.929 0.94,0.929 0.81,0.929 false
*1 Cylinder Boot
*2 Set Ring
*3 Piston


Install the front disc brake piston to the disc brake cylinder.

NOTICE:

Do not forcibly install the piston to the cylinder.



b.

Install the cylinder boot to the disc brake cylinder.

NOTICE:

Securely install the cylinder boot into the groove of the disc brake cylinder.



c.

Using a screwdriver, install a new set ring.

HINT:

Tape the screwdriver tip before use.


NOTICE:

Do not damage the cylinder boot.