Home › Brake › BRAKE (REAR) › REAR BRAKE
RM30B0U _54 Brake _010845 BRAKE (REAR) _0057932 REAR BRAKE A

BRAKE (REAR)  REAR BRAKE  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.REMOVE CYLINDER BOOT

a.
C127288
2.646,1.417 2.646,1.948 2.646,1.948 2.563,1.948 false 0.875,1.188 0.688,1.51 0.688,1.51 0.688,1.625 false 0.615,1.656 0.833,1.823 0.219,0.167 10 *a 2.292,1.875 2.521,2.042 0.229,0.167 10 *a
*a Protective Tape


Using a screwdriver, pry out the set ring and boot.

HINT:

Tape the screwdriver tip before use.


NOTICE:

Be careful not to damage the rear disc brake piston and rear disc brake cylinder assembly.



Hide 2.REMOVE REAR DISC BRAKE PISTON

a.
C278616
0.604,1.646 0.604,1.292 0.604,1.292 0.708,1.01 false 0.563,1.708 0.781,1.875 0.219,0.167 10 *a
*a Cloth


Place a piece of cloth between the rear disc brake piston and rear disc brake cylinder assembly.


b.

Apply compressed air to remove the rear disc brake piston from the rear disc brake cylinder assembly.

CAUTION:

Do not place your fingers in front of the piston when using compressed air.


NOTICE:

Be careful not to spatter the brake fluid.



Hide 3.REMOVE PISTON SEAL

a.
C127290
1.719,1.302 0.99,1.698 0.99,1.698 0.99,1.781 false 0.906,1.792 1.073,1.938 0.167,0.146 10 false *a
*a Protective Tape


Using a screwdriver, remove the piston seal from the rear disc brake cylinder assembly.

HINT:

Tape the screwdriver tip before use.


NOTICE:

Be careful not to damage the inner surface of the cylinder or piston seal groove.



Hide 4.REMOVE REAR DISC BRAKE BLEEDER PLUG CAP

Hide 5.REMOVE REAR DISC BRAKE BLEEDER PLUG

a.

Remove the rear disc brake bleeder plug from the rear disc brake cylinder assembly.