Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR
RM30B0U _54 Brake _010842 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0057934 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.REMOVE FRONT FENDER LINER LH

a.

Partially remove the front fender liner.

HINT:

It is not necessary to fully remove the fender liner. Partially remove it so that the speed sensor connector can be disconnected in a later step.



Hide 3.REMOVE FRONT SPEED SENSOR LH

a.
C274696

Disconnect the front speed sensor connector.


b.
C274697
2.083,0.448 2.24,0.615 0.156,0.167 10 A 1.167,1.646 1.323,1.813 0.156,0.167 10 B 0.938,1.135 1.094,1.302 0.156,0.167 10 C

Remove the sensor clip labeled A, bolt labeled B and sensor clamp labeled C.


c.
C274698
2.292,2.219 2.427,2.417 0.135,0.198 10 D 3.219,1.656 3.375,1.885 0.156,0.229 10 E 2.74,1.844 2.854,2.031 0.115,0.188 10 F

Remove the sensor clip labeled D, bolt labeled E and sensor clamp labeled F.


d.
C274699

Remove the bolt and front speed sensor from the knuckle.

NOTICE:

Keep the sensor tip and sensor installation hole free from foreign matter.