FREEZE FRAME DATA
Whenever a meter DTC is detected, the combination meter assembly stores the current vehicle state as Freeze Frame Data.
CHECK FREEZE FRAME DATA
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Trouble Codes.
According to the Techstream display, select a DTC that stored Freeze Frame Data.
Read the freeze frame data recorded when the DTC was stored.
| Tester Display | Condition | Displayed Item |
|---|---|---|
| B1507 | Open in Turn Signal Circuit | ·
Trip ·
Elapsed time after turning the ignition switch to ON |
| B1508 | Short in Turn Signal / Hazard Flasher Circuit | |
| U0100 | Lost Communication with ECM / PCM "A" | |
| U0129 | Lost Communication with Brake System Control Module | |
| U0131 | Lost Communication with Power Steering Control Module | |
| U0142 | Lost Communication with Body Control Module "B" | |
| U0151 | Lost Communication with Restraints Control Module |
CLEAR FREEZE FRAME DATA
Clearing the DTCs will also clear the freeze frame data.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear DTCs and Freeze Frame Data.