Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM
RM30B0U _58 Vehicle Interior _010074 SUPPLEMENTAL RESTRAINT SYSTEMS _0058017 AIRBAG SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  DTC CHECK / CLEAR  


CHECK DTC (Using SST Check Wire)


a.
C204945
1.802,1.344 1.802,1.865 1.802,1.865 1.99,1.865 false 1.635,0.792 1.635,0.271 1.635,0.271 1.823,0.271 false 2.031,1.771 2.51,1.979 0.479,0.208 10 TC 1.865,0.177 2.167,0.375 0.302,0.198 10 CG

Check for DTCs (present trouble code).

i.

Turn the ignition switch to ON and wait for approximately 60 seconds.


ii.

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST
09843-18040  

NOTICE:

Connect the correct terminals to avoid a malfunction.




b.

Check for DTCs (past trouble code).

i.

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST
09843-18040  

NOTICE:

Connect the correct terminals to avoid a malfunction.



ii.

Turn the ignition switch to ON and wait for approximately 60 seconds.



c.

Read the DTCs.

E256442
0.469,0.042 2.677,0.417 2.208,0.375 12 false Normal System Code (without Past Trouble Code): 4.646,0.063 6.625,0.438 1.979,0.375 12 false Normal System Code (with Past Trouble Code): 2.073,1.792 5.625,1.99 3.552,0.198 12 false Trouble Code (Example Codes 11 and 31): 0.333,0.906 0.563,1.094 0.229,0.188 10 false On 0.333,1.292 0.573,1.479 0.24,0.188 10 false Off 4.51,0.917 4.74,1.104 0.229,0.188 10 false On 4.5,1.302 4.74,1.49 0.24,0.188 10 false Off 1.01,0.792 1.969,0.948 0.958,0.156 10 false 0.25 seconds 1.125,1.438 2.031,1.594 0.906,0.156 10 false 0.25 seconds 5.51,1.427 6.406,1.583 0.896,0.156 10 false 0.25 seconds 2.365,2.177 3.146,2.354 0.781,0.177 10 false 0.5 seconds 3.573,3.125 4.375,3.281 0.802,0.156 10 false 0.5 seconds 2.344,3.115 3.156,3.271 0.813,0.156 10 false 1.5 seconds 3.271,2.167 4.063,2.313 0.792,0.146 10 false 2.5 seconds 4.135,2.146 4.938,2.302 0.802,0.156 10 false 4.0 seconds 5.302,0.792 6.188,0.948 0.885,0.156 10 false 0.75 seconds 4.458,3.042 4.969,3.219 0.51,0.177 10 false Repeat 2.823,3.49 3.344,3.656 0.521,0.167 10 false DTC 11 3.469,3.49 4,3.656 0.531,0.167 10 false DTC 31

i.

Read the blinking patterns of the DTCs. As examples, the blinking patterns for the normal system code and trouble codes 11 and 31 are shown in the illustration.

·

Normal system code indication (without past trouble code):The light blinks twice per second.

·

Normal system code indication (with past trouble code):When a past trouble code is stored in the airbag sensor assembly, the light blinks only once per second.

·

Trouble code indication: Each digit of a DTC is separated by a 1.5 second pause.


If there is more than 1 code, there is a 2.5 second pause between each code. After all the codes are output, there is a 4.0 second pause, and then all codes are repeated.

HINT:
·

If 2 or more malfunctions are found, the indication begins with the smaller-numbered code.

·

If DTCs are output without connecting the terminals, proceed to "Diagnosis Circuit".

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>Diagnosis Circuit






CLEAR DTC (Using SST Check Wire)


a.

When the ignition switch is turned off, the DTCs are cleared.

HINT:

Depending on the DTC, the code may not be cleared by turning off the ignition switch. In this case, proceed to the next step.



b.

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3, and then turn the ignition switch to ON.

SST
09843-18040  


c.

Disconnect terminal TC of the DLC3 within 3 to 10 seconds after the DTCs are output and check that the SRS warning light comes on after 3 seconds.


d.

Within 2 to 4 seconds after the SRS warning light comes on, connect terminals 13 (TC) and 4 (CG) of the DLC3.


e.

Check that the SRS warning light goes off within 2 to 4 seconds after connecting terminals 13 (TC) and 4 (CG) of the DLC3. Then, disconnect terminal 13 (TC) within 2 to 4 seconds after the SRS warning light goes off.


f.

Check that the SRS warning light comes on again within 2 to 4 seconds after disconnecting terminal 13 (TC). Then, reconnect terminals 13 (TC) and 4 (CG) within 2 to 4 seconds after the SRS warning light comes on.


g.

Check that the SRS warning light goes off within 2 to 4 seconds after connecting terminals 13 (TC) and 4 (CG) of the DLC3. Also, check that the normal system code is output within 1 second after the SRS warning light goes off. If DTCs are not cleared, repeat this procedure until the codes are cleared.

E256443
0.198,0.406 1.156,0.594 0.958,0.188 10 Ignition Switch 0.031,1.177 1.271,1.365 1.24,0.188 10 DLC3 (TC and CG) 0.188,2.146 1.521,2.354 1.333,0.208 10 SRS Warning Light* 2.719,1.823 3.531,2.031 0.813,0.208 10 0.5 seconds 0.219,2.594 1.458,2.771 1.24,0.177 10 T1: 0 to ∞ seconds 0.219,2.917 2.271,3.125 2.052,0.208 10 T2: approximately 6 seconds 0.219,3.24 1.427,3.438 1.208,0.198 10 T3: 3 to 5 seconds 0.219,3.552 1.479,3.76 1.26,0.208 10 T4: 3 to 10 seconds 0.219,3.875 1.417,4.052 1.198,0.177 10 T5: 2 to 4 seconds 0.219,4.198 1.406,4.375 1.188,0.177 10 T6: 1 to 5 seconds 0.219,4.521 1.573,4.708 1.354,0.188 10 T7: within 1 second 2.333,4.125 6.844,4.365 4.51,0.24 10 *: The past trouble code in the illustration shows DTC 21 as an example. 2.49,3.479 2.688,3.708 0.198,0.229 10 T1 5.969,3.479 6.198,3.708 0.229,0.229 10 T7 4.427,3.479 4.625,3.708 0.198,0.229 10 T6 4.177,3.479 4.365,3.708 0.188,0.229 10 T5 3.75,3.479 3.969,3.708 0.219,0.229 10 T4 3.271,3.479 3.49,3.708 0.219,0.229 10 T3 2.865,3.479 3.104,3.708 0.24,0.229 10 T2 4.948,3.479 5.135,3.708 0.188,0.229 10 T6 4.698,3.479 4.885,3.708 0.188,0.229 10 T5 5.458,3.479 5.646,3.708 0.188,0.229 10 T6 5.208,3.479 5.396,3.708 0.188,0.229 10 T5 5.719,3.479 5.948,3.708 0.229,0.229 10 T5 1.448,0.396 2.083,0.594 0.635,0.198 10 ON 1.448,0.823 1.885,1.021 0.438,0.198 10 Off 1.365,1.531 2.417,1.719 1.052,0.188 10 Connected 1.365,1.156 2.281,1.333 0.917,0.177 10 Disconnected 1.625,2.135 1.885,2.302 0.26,0.167 10 On 1.625,2.5 1.948,2.677 0.323,0.177 10 Off 3.583,2.802 4.177,3.219 0.594,0.417 10 1.5 seconds 3.792,1.813 4.615,2.021 0.823,0.208 10 0.5 seconds 5.354,1.76 6.229,1.969 0.875,0.208 10 0.25 seconds 6.281,1.75 7.146,1.958 0.865,0.208 10 0.25 seconds



CHECK DTC (Using the Techstream)


a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / SRS Airbag / Trouble Codes.

Body Electrical > SRS Airbag > Trouble Codes
50001 188


CLEAR DTC (Using the Techstream)


a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / SRS Airbag / Trouble Codes.


e.

Clear the DTCs.

Body Electrical > SRS Airbag > Clear DTCs
50002 188