Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM
RM30B0U _58 Vehicle Interior _009991 SEAT BELT _0057997 SEAT BELT WARNING SYSTEM U

SEAT BELT  SEAT BELT WARNING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / Combination Meter, Occupant Detection or SRS Airbag / Data List.


e.

Read the Data List according to the display on the Techstream.

Body Electrical > Combination Meter > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Driver Side Seatbelt Warning Buzzer Driver side seat belt warning buzzer ON or OFF Customized value displayed -
P-Seatbelt Warning Buzzer Front passenger side seat belt warning buzzer ON or OFF Customized value displayed -
Body Electrical > Occupant Detection > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Passenger Buckle SW Front passenger side buckle switch Set, Unset or NG Set: Front seat belt RH fastened
Unset: Front seat belt RH not fastened
NG: Data is not determined
-
Body Electrical > SRS Airbag > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Left side Buckle SW Driver side buckle switch Unset, Set or NG Unset: Front seat belt LH not fastened
Set: Front seat belt LH fastened
NG: Data is not determined
-
Right side Buckle SW Front passenger side buckle switch Unset, Set or NG Unset: Front seat belt RH not fastened
Set: Front seat belt RH fastened
NG: Data is not determined
-


ACTIVE TEST


Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Perform the Active Test according to the display on the Techstream.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Driver Side Seat Belt Front seat belt warning light OFF/ON -