Home › Drivetrain › GF1A TRANSFER / 4WD / AWD › DYNAMIC TORQUE CONTROL AWD SYSTEM
RM30B0U _52 Drivetrain _009983 GF1A TRANSFER / 4WD / AWD _0058072 DYNAMIC TORQUE CONTROL AWD SYSTEM U

GF1A TRANSFER / 4WD / AWD  DYNAMIC TORQUE CONTROL AWD SYSTEM  TERMINALS OF ECU  


CHECK 4WD ECU ASSEMBLY


C270073
3.385,0.135 3.813,0.438 0.427,0.302 3.469,0.208 3.938,0.375 0.469,0.167 10 G86

a.

Measure the voltage and resistance of the connector.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
G86-10 (4WDS) - G86-4 (GND) R - W-B AWD lock switch signal Ignition switch ON
AWD lock switch OFF → ON
11 to 14 V → Below 1 V
G86-6 (CANH) - G86-5 (CANL) L - W HIGH-level CAN bus wire - LOW-level CAN bus wire Cable disconnected from negative (-) battery terminal 54 to 69 Ω
G86-4 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω
G86-3 (IG1) - G86-4 (GND) V - W-B Power source voltage Ignition switch ON 11 to 14 V
G86-2 (SLC+) - G86-1 (SLC-) W - B 4WD linear solenoid signal D position, Idling Pulse generation (See waveform 1)

If the result is not as specified, the 4WD ECU assembly may have a malfunction.


b.
C170221
2.917,1.729 3.271,1.865 0.354,0.135 10 GND

Using an oscilloscope, check the waveform 1.

Waveform 1 (Reference)
Item Content
Terminal No. (Symbol) G86-2 (SLC+) - G86-1 (SLC-)
Tester Range 2 V/DIV., 1 msec./DIV.
Condition D position, Idling