If the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake actuator assembly) stores DTC C1440 while VSC operation is temporarily disabled.
It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes, which automatically clears DTC C1440, after the vehicle is returned to a normal position.
DTC C1440 and the yaw rate and acceleration sensor DTC are stored when the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle and either of the following conditions is met:
The yaw rate and acceleration sensor (airbag sensor assembly) is installed at an angle.
The yaw rate and acceleration sensor (airbag sensor assembly) signal output is stuck.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1440 | Steering Angle Sensor Unusual Bank Angle Detected | Driving at a steep bank angle | Yaw rate and acceleration sensor (Airbag sensor assembly) |
Clear the DTCs.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
Perform a road test.
Check if the same DTC is output.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC C1440 is output |
| DTC C1440 is not output |
| Yaw rate and acceleration sensor DTC is output |
DTC C1440 is output
DTC C1440 is not output
Yaw rate and acceleration sensor DTC is output
Clear the DTCs.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
If the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake actuator assembly) stores DTC C1440 while VSC operation is temporarily disabled.
It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes, which automatically clears DTC C1440, after the vehicle is returned to a normal position.
| Proceed to |
|---|
| NEXT |
NEXT