Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR
RM30B0U _58 Vehicle Interior _009988 HEATING / AIR CONDITIONING _0054983 COMPRESSOR G

HEATING / AIR CONDITIONING  COMPRESSOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT COMPRESSOR ASSEMBLY WITH PULLEY (COMPRESSOR SOLENOID)

a.
I105051
0.16,0.115 0.341,0.289 0.181,0.174 10 *a 0.805,1.71 1.187,1.883 0.382,0.174 10 SOL+ 2.216,1.71 2.598,1.883 0.382,0.174 10 SOL- 1.963,1.25 2.388,1.676 false 1.493,1.25 1.067,1.676 false
*a Component without harness connected
(Compressor Assembly with Pulley)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 (SOL+) - 1 (SOL-) 20°C (68°F) 10.1 to 11.1 Ω


If the result is not as specified, replace the compressor assembly with pulley.


Hide 2.INSPECT MAGNET CLUTCH ASSEMBLY (w/ Magnet Clutch)

a.
E270992
1.875,0.958 2.26,0.448 true 1.552,0.958 1.146,0.448 true 0.083,0.094 0.396,0.25 0.313,0.156 10 *a 2.313,0.302 2.813,0.469 0.5,0.167 10 SSR+ 0.802,0.323 1.302,0.49 0.5,0.167 10 SSR-
*a Component without harness connected
(Magnet Clutch Assembly)


Inspect the resistance of the lock sensor.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (SSR+) - 2 (SSR-) 20°C (68°F) 160 to 320 Ω at 20°C (68°F)


If the result is not as specified, replace the cooler compressor assembly.



b.
E271007
0.396,1.396 0.583,0.958 true 0.052,0.094 0.365,0.25 0.313,0.156 10 false *a 0.198,1.448 0.656,1.646 0.458,0.198 10 false MG+
*a Component without harness connected
(Magnet Clutch Assembly)


Inspect the operation of the magnet clutch.

i.

Connect the positive (+) lead of the 12 V battery to terminal 3 (MG+) of the connector and the negative (-) lead to the body ground and check that an operating noise can be heard and that the magnet clutch hub and rotor lock.

If the result is not as specified, replace the cooler compressor assembly.