1.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY RH
| *1 | Connector A |
| *2 | Connector B |
| *3 | Thermostat |
| *a | Component without harness connected
(Front Seat Cushion Heater Assembly RH) |
Check the front seat cushion heater assembly RH.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-4 - B-3 | Seat cushion heater temperature 20°C (68°F) | 3.25 to 3.31 Ω |
| A-2 - B-2 | 1.78 to 1.82 Ω | |
| A-1 - B-1 | Below 1 Ω |
If the result is not as specified, replace the front seat cushion heater assembly RH.
Check the thermostat resistance.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-4 - B-3 | Thermostat temperature 42°C (108°F) | 10 kΩ or higher |
| A-2 - B-2 | 10 kΩ or higher |
If the result is not as specified, replace the front seat cushion heater assembly RH.