Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM30B0U _55 Steering _010966 STEERING GEAR / LINKAGE _0058245 STEERING GEAR A

STEERING GEAR / LINKAGE  STEERING GEAR  DISASSEMBLY  


PROCEDURE

Hide 1.FIX STEERING GEAR ASSEMBLY

a.
C151611
1.823,0.708 1.99,0.26 1.99,0.26 2.104,0.26 false 1.5,1.073 0.99,1.458 0.99,1.458 0.844,1.458 false 2.156,0.188 2.448,0.354 0.292,0.167 10 SST 0.667,1.365 0.979,1.521 0.313,0.156 10 *a
*a Protective tape


Using SST, fix the power steering gear assembly.

HINT:

Apply protective tape to SST before use.


SST
09612-00012  


Hide 2.REMOVE TIE ROD END SUB-ASSEMBLY LH

a.
C275662
0.813,1.76 1.125,1.917 0.313,0.156 10 *a
*a Matchmark


Put matchmarks on the No. 2 tie rod end sub-assembly and rack end.


b.

Remove the No. 2 tie rod end sub-assembly and lock nut.


Hide 3.REMOVE TIE ROD END SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 4.REMOVE STEERING RACK BOOT CLIP

a.

Using pliers, remove the 2 steering rack boot clips.


Hide 5.REMOVE NO. 2 STEERING RACK BOOT CLAMP

a.
C110164

Using a screwdriver, remove the No. 2 steering rack boot clamp.

NOTICE:

Be careful not to damage the steering rack boot.



Hide 6.REMOVE NO. 1 STEERING RACK BOOT CLAMP

HINT:

Use the same procedure described for the No. 2 steering rack boot clamp.


Hide 7.REMOVE NO. 2 STEERING RACK BOOT

a.

Remove the No. 2 steering rack boot.


Hide 8.REMOVE NO. 1 STEERING RACK BOOT

a.

Remove the No. 1 steering rack boot.