Home › Steering › STEERING COLUMN › STEERING WHEEL
RM30B0U _55 Steering _010850 STEERING COLUMN _0058248 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  INSTALLATION  


PROCEDURE

Hide 1.INSTALL STEERING WHEEL BOSS LOWER COVER

a.

Attach the 2 guide pins and 4 claws, to install the lower cover.


Hide 2.INSTALL STEERING PAD SWITCH ASSEMBLY

a.

Attach the 6 claws and 2 pins to install the steering pad switch assembly.


b.

Install the 2 screws.


c.

Connect the connector to the spiral cable.

HINT:

If the vehicle is equipped with a shift paddle switch, connect the connector and the connector clamp.



Hide 3.INSTALL CRUISE CONTROL SWITCH WIRE

a.

Install the cruise control switch wire to the cruise control main switch.


Hide 5.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 7.INSTALL STEERING WHEEL ASSEMBLY

a.

Align the matchmarks on the steering wheel assembly and steering main shaft.


b.

Install the steering wheel assembly set nut.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


c.

Connect the connectors to the spiral cable sub-assembly.


Hide 9.INSPECT STEERING WHEEL CENTER POINT

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).