Home › Steering › STEERING COLUMN › STEERING WHEEL
RM30B0U _55 Steering _010850 STEERING COLUMN _0058248 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS. Read the precautionary notices concerning the SRS before servicing (Click here Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 5.REMOVE STEERING WHEEL ASSEMBLY

a.

Remove the steering wheel assembly set nut.


b.
C275631
0.781,0.635 1.021,0.635 1.021,0.635 0.792,0.698 true 1.01,0.542 1.323,0.698 0.313,0.156 10 *a
*a Matchmark


Put matchmarks on the steering wheel assembly and steering main shaft.


c.

Disconnect the connectors from the spiral cable.


d.
C275632
2.417,0.854 3.083,0.479 true 0.958,1.604 1.271,1.76 0.313,0.156 10 *a 3.115,1.375 3.427,1.531 0.313,0.156 10 *b 3.125,0.385 3.427,0.646 0.302,0.26 10 SST
*a Hold
*b Turn


Using SST, remove the steering wheel assembly.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05021)

NOTICE:

Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.



Hide 6.REMOVE CRUISE CONTROL MAIN SWITCH

Hide 7.REMOVE CRUISE CONTROL SWITCH WIRE

a.

Remove the cruise control switch wire from the cruise control main switch.


Hide 8.REMOVE STEERING PAD SWITCH ASSEMBLY

a.
C275633

Remove the 2 screws.


b.

Detach the 2 pins and 6 claws and remove the steering pad switch.

HINT:

If the vehicle is equipped with a shift paddle switch, disconnect the connector and the connector clamp.



Hide 9.REMOVE STEERING WHEEL BOSS LOWER COVER

a.
C275675

Detach the 2 guide pins and 4 claws, and remove the lower cover.