CHECK DLC3
Check the DLC3.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>GENERAL INFORMATION
INSPECT BATTERY VOLTAGE
Measure the vehicle battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery.
SELF-DIAGNOSTIC MODE
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Utility / Wireless Door Lock Diagnosis Mode.
| Tester Display |
|---|
| Wireless Door Lock Diagnosis Mode |
Proceed to the next step in accordance with the prompts on the Techstream screen.
Check that the system has switched to self-diagnostic mode by checking the interior light output pattern.
Check that the system has switched to self-diagnostic mode by checking the wireless door lock buzzer output pattern.
Check the diagnostic outputs when a door control transmitter assembly switch is pressed. The diagnostic outputs can be checked by the interior light and wireless door lock buzzer patterns.
| Interior Light Output | Suspected Area |
|---|---|
| A | Normal (No malfunction) |
| B | Register wireless code |
| C | Wave interference or malfunction of a related component |