Home › Drivetrain › U760E AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH
RM30B0U _52 Drivetrain _010989 U760E AUTOMATIC TRANSMISSION / TRANSAXLE _0058563 PARK / NEUTRAL POSITION SWITCH A

U760E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  REMOVAL  


PROCEDURE

Hide 1.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 2.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 3.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 4.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.
C132236

Remove the nut and transmission control cable assembly from the transmission control shaft lever.


b.

Disconnect the connector from the park/neutral position switch assembly.


c.
C136685

Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.


d.
C135732

Remove the 2 bolts and park/neutral position switch assembly from the automatic transaxle assembly.

NOTICE:

Before removing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the manual valve lever shaft sub-assembly. Be sure to remove the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral switch cannot be reinstalled correctly.