1.INSPECT COMBINATION SWITCH ASSEMBLY
| *a | Component without harness connected
(Combination Switch) |
Measure the resistance according to the value(s) inthe table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 2 (MSW1) - 4 (MSW2) | Combination switch (SPORT) on | Below 1 Ω |
| 2 (MSW1) - 4 (MSW2) | Combination switch (SPORT) off | 10 kΩ or higher |
If the result is not as specified, replace the combination switch assembly.