1.REMOVE FRONT DRIVE SHAFT ASSEMBLY
2.REMOVE TRANSAXLE CASE OIL SEAL LH
Using SST, tap out the transaxle case oil seal LH.
3.REMOVE TRANSAXLE CASE OIL SEAL RH
Using SST, tap out the transaxle case oil seal RH.
4.INSTALL TRANSAXLE CASE OIL SEAL RH
Using SST and a hammer, tap in a new transaxle case oil seal RH.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Check that the transaxle case oil seal RH is installed in the correct direction.
Coat the lip of the transaxle case oil seal RH with MP grease.
5.INSTALL TRANSAXLE CASE OIL SEAL LH
Using SST and a hammer, tap in a new transaxle case oil seal LH.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Check that the transaxle case oil seal LH is installed in the correct direction.
Coat the lip of the transaxle case oil seal LH with MP grease.
6.INSTALL FRONT DRIVE SHAFT ASSEMBLY