This DTC is stored when a key with a different vehicle serial number is inserted into the ignition key cylinder.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2795 | Unmatched Key Code | A key with a different vehicle serial number is inserted into the ignition key cylinder (1 trip detection logic*). | ·
Key ·
Transponder key ECU assembly |
DTC Output Confirmation Operation:
Insert the key into the ignition key cylinder. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started | - |
| DTC No. | Data List and Active Test |
|---|---|
| B2795 | - |
If the transponder key ECU assembly or key is replaced, refer to Registration.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
When using the Techstream with the vehicle ignition switch off, connect the Techstream to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Immobiliser. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Insert and remove each registered key one at a time, and check for DTCs each time.
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
If DTC B2795 is stored, check for DTCs with the next key after clearing the DTCs.
| Proceed to |
|---|
| B2795 is not output |
| DTC B2795 is output for all of the keys |
| DTC B2795 is output for any of the keys |
B2795 is not output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTC B2795 is output for all of the keys
DTC B2795 is output for any of the keys
Check that the ignition switch can be turned to ON using the key for which the DTC was stored.
Ignition switch can be turned to ON using the key (for which the DTC was stored).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Reregister the key ID code with the transponder key ECU assembly.
Registration procedure can be completed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG