DESCRIPTION
The certification ECU (smart key ECU assembly) and ECM control the vehicle immobiliser system functions. Immobiliser system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3).
In some cases, a malfunction may be occurring in the immobiliser system even though the security indicator light is not illuminated.
When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.
CHECK DLC3
Check the DLC3.
Click hereGeneral>INTRODUCTION>HOW TO USE THIS MANUAL>GENERAL INFORMATION
INSPECT BATTERY VOLTAGE
Measure the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery.
START FUNCTION PROBLEM SYMPTOMS
| Symptom | Suspected Area | Component Malfunction | Possible Output DTCs | Related Data List Item |
|---|---|---|---|---|
|
*1: Refer to Problem Symptoms Table for Smart Key System (for Start Function). *2: Refer to Problem Symptoms Table for Steering Lock System. |
||||
| Engine cannot be started*1 | Certification ECU (smart key ECU assembly) | Open or short circuit inside ECU | ·
B278A ·
B2799 ·
B279A |
·
Ignition Switch ·
#Codes ·
Immobilizer when IG=ON ·
Immobiliser ·
Master Key ·
Sub Key ·
BCC Malfunction ·
Abnormal Status ·
Different Encrypt Code ·
Different Serial Number ·
Frame Error ·
Response ·
Wireless Starter Com ID ·
Wireless C Code ·
Engine Start Condition ·
ID-BOX Sleep Condition ·
ID-BOX Start Condition ·
Engine Start Request ·
3bit Code Request ·
L Code Check ·
Unlock Request Receive ·
Lock Request Receive ·
L Code Check (Past) ·
EFI Code Receive ·
EFI communication |
| Engine cannot be started*1 | Certification ECU (smart key ECU assembly) | Open or short circuit inside ECU | ·
B2799 ·
B279A |
·
Immobilizer when IG=ON ·
Immobiliser ·
Master Key ·
Sub Key ·
BCC Malfunction ·
Abnormal Status ·
Different Encrypt Code ·
Different Serial Number ·
Frame Error ·
Response ·
ID-BOX Sleep Condition ·
ID-BOX Start Condition ·
Engine Start Request ·
3bit Code Request ·
L Code Check ·
Lock Request Receive ·
L Code Check (Past) ·
EFI Code Receive ·
EFI communication |
| ECM | Open or short circuit inside ECU | ·
B2799 ·
B279A ·
B279C |
EFI Code Receive | |
| SFI system | ECM incompatible with installed immobiliser system | B279C | ·
Engine Start Condition ·
EFI Code Receive |
|
| Power source mode cannot be changed*1 | Engine switch | Open or short circuit inside switch | B278A | ·
Ignition Switch ·
Unlock Request Receive ·
Lock Request Receive |
| Certification ECU (smart key ECU assembly) | Open or short circuit inside ECU | ·
B2271 ·
B2274 |
·
Ignition Switch ·
Immobilizer when IG=ON ·
Immobiliser |
|
| Steering lock/unlock not possible*2 | Steering lock ECU (steering lock actuator assembly) | ·
Open or short circuit inside ECU ·
Actuator stuck |
·
B2781 ·
B2782 ·
B2788 |
·
Unlock Request Receive ·
Lock Request Receive |