READ DATA LIST
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Using the Techstream to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Communication D-Door Motor | Connection status between front power window regulator motor assembly (for Driver Side) and main body ECU (multiplex network body ECU) | OK or STOP | OK: Connection
STOP: No connection |
·
w/ Jam Protection Function When there is a malfunction, a DTC is stored. ·
w/o Jam Protection Function "STOP" is always displayed as there is no connection to the LIN communication system. |
| Communication Slide Roof | Connection status between sliding roof drive gear sub-assembly and main body ECU (multiplex network body ECU) | OK or STOP | OK: Connection
STOP: No connection |
·
w/ Sliding Roof System: When there is a malfunction, a DTC is stored. ·
w/o Sliding Roof System: "STOP" is always displayed as there is no connection to the LIN communication system. |
| The Number of DTC | Number of trouble codes | Min.: 0, Max.: 255 | Number of DTCs displayed | - |