1.CHECK TRANSFER OIL
Stop the vehicle on a level surface.
Using a 10 mm straight hexagon wrench and 10 x 12 mm long offset wrench, remove the No. 2 transfer case plug (for filler) and gasket.
| *a | 0 to 5.0 mm (0 to 0.196 in.) |
Check that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the No. 2 transfer case plug (for filler) hole.
If the result is not as specified, add transfer oil.
Toyota Genuine Differential gear oil LT API GL-5 or equivalent
SAE 75W-85
When adding oil, pour it slowly.
Too much or too little oil will lead to transfer problems.
If the oil level is low, refill oil after checking for oil leaks.
| *1 | 10 mm Straight Hexagon Wrench |
| *2 | 12 mm Hexagon Socket Wrench |
| *3 | 10 x 12 mm Long Offset Wrench |
Using a 10 mm straight hexagon wrench, 12 mm hexagon socket wrench and 10 x 12 mm long offset wrench, install a new gasket into the No. 2 transfer case plug (for filler) and then install the No. 2 transfer case plug (for filler).
Use the formula to calculate special torque values for situations where a offset wrench is combined with a torque wrench (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When tightening, combine the offset wrench with the torque wrench so that they are in a straight line.