Home › Drivetrain › U760E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM
RM30B0U _52 Drivetrain _010989 U760E AUTOMATIC TRANSMISSION / TRANSAXLE _0060247 AUTOMATIC TRANSAXLE SYSTEM C

U760E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  U0100  Lost Communication with ECM / PCM "A"  


DESCRIPTION

The engine control unit and the transmission control unit are located inside the ECM. The engine control unit intercommunicates with the transmission control unit with the Controller Area Network (CAN).

If there is a problem in this intercommunication, the ECM stores a DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
U0100 Lost Communication with ECM / PCM "A" All conditions are met for 1.25 sec. (1-trip detection logic):
·

Ignition switch is ON

·

Battery voltage is 10.5 V or higher

·

No intercommunication between engine control unit and transmission control unit


ECM Comes on DTC stored

MONITOR STRATEGY

Related DTCs U0100: Verify communication
Required Sensors/Components (Main) ECM
Required Sensors/Components (Related) -
Frequency of Operation Continuous
Duration 1.25 sec.
MIL Operation Immediate
Sequence of Operation None

TYPICAL ENABLING CONDITIONS

The monitor will run whenever the following DTCs are not stored None
Battery Voltage 10.5 V or higher
Ignition Switch ON
Starter OFF

TYPICAL MALFUNCTION THRESHOLDS

Communication between engine control unit and transmission control unit No communication

CAUTION / NOTICE / HINT

NOTICE:
·

Perform registration and/or initialization when parts related to the automatic transaxle are replaced.

Click hereDrivetrain>U760E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>PRECAUTION

·


PROCEDURE

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC U0100)
a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Powertrain > Engine and ECT > Trouble Codes
50001 234

d.

Check if DTCs are output.

Result:
Result Proceed to
Only U0100 is output A
U0100 and other DTCs are output B




A

B