Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR
RM30B0U _59 Vehicle Exterior _011369 MIRROR (EXT) _0060870 OUTER REAR VIEW MIRROR A

MIRROR (EXT)  OUTER REAR VIEW MIRROR  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL OUTER MIRROR RETRACTOR LH (except TMMC Made)

a.

Install the support with the 4 screws.


b.

Pass a new harness sub-assembly through the frame sub-assembly.


c.

Connect the connector.


d.
B342360

Temporarily install a new frame sub-assembly as shown in the illustration.


e.

Install the new frame sub-assembly with the 2 screws.

Torque:
2.0 N*m (20 kgf*cm, 18 in.*lbf)


f.

Using a T25 "TORX" socket wrench, install 3 new screws.

Torque:
3.3 N*m (34 kgf*cm, 29 in.*lbf)


g.

Install the gasket sub-assembly to the outer rear view mirror assembly LH.


h.
B342385
1.448,0.958 1.448,0.708 1.448,0.708 0.833,0.708 false 1.521,1.719 1.667,1.896 0.146,0.177 10 false A 0.573,0.635 0.771,0.813 0.198,0.177 10 false *1
*1 Tape


Wrap new tape as shown in the illustration.

Area Measurement
A 50 mm


Hide 2.INSTALL LOWER OUTER MIRROR COVER LH (except TMMC Made)

a.
B340669

Attach the 5 claws to install the lower outer mirror cover LH.


b.

Attach the 5 guides and install the gasket.


Hide 3.INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH

Hide 5.INSTALL OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH