Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH
| *1 | Moulding Remover |
| *2 | Protective Tape |
Put protective tape around the outer rear view mirror sub-assembly LH.
Using a moulding remover, detach the 2 claws of the outer rear view mirror sub-assembly LH as shown in the illustration.
| *1 | Moulding Remover |
| *2 | Protective Tape |
Using a moulding remover, detach the 2 claws of the outer rear view mirror sub-assembly LH as shown in the illustration.
w/ Mirror Heater:
Disconnect the connector and remove the outer rear view mirror sub-assembly LH.
w/ Blind Spot Monitor:
Disconnect the connector and remove the outer rear view mirror sub-assembly LH.