Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH › 2012.12–2013.11
RM30B0U _51 Engine / Hybrid System _010069 CRUISE CONTROL _0060913 CRUISE CONTROL MAIN SWITCH G

CRUISE CONTROL  CRUISE CONTROL MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT CRUISE CONTROL MAIN SWITCH

a.

Measure the resistance according to the value(s) in the table below.

B341309
5.854,1.115 5.979,0.708 5.979,0.708 6.167,0.708 false 6.229,0.635 6.542,0.792 0.313,0.156 10 *1 2.313,2.396 2.625,2.552 0.313,0.156 10 *a 6.688,1.24 7,1.396 0.313,0.156 10 *b 5.417,0.552 5.729,0.708 0.313,0.156 10 *c 5.844,2.365 6.156,2.521 0.313,0.156 10 *d 4.75,2.063 5.063,2.219 0.313,0.156 10 *e
*1 Cruise Control Switch (ON-OFF button) - -
*a Component without harness connected
(Cruise Control Main Switch)
*b ON-OFF
*c +/RES *d -/SET
*e CANCEL - -


Standard Resistance:
Tester Connection Condition Specified Condition
1 - 3 Cruise control switch (ON-OFF button) released 1 MΩ or higher
Cruise control switch (ON-OFF button) pushed Below 2.5 Ω
+/RES 235 to 245 Ω
-/SET 617 to 643 Ω
CANCEL 1509 to 1571 Ω


If the result is not as specified, replace the cruise control main switch.