Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SWITCH
RM30B0U _51 Engine / Hybrid System _010069 CRUISE CONTROL _0060914 LANE DEPARTURE ALERT SWITCH G

CRUISE CONTROL  LANE DEPARTURE ALERT SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT TELLTALE LIGHT ASSEMBLY (LANE DEPARTURE ALERT SWITCH)

a.
B339082
1.865,1.104 2.229,0.49 true 2.417,1.865 2.646,1.427 true 0.115,0.146 0.427,0.302 0.313,0.156 10 false *a 2.26,0.385 2.719,0.583 0.458,0.198 10 false ECU 2.365,1.885 2.823,2.083 0.458,0.198 10 false E
*a Component without harness connected
(Telltale Light Assembly (Lane Departure Alert Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (ECU) - 13 (E) LDA switch pushed Below 1 Ω
6 (ECU) - 13 (E) LDA switch not pushed 10 kΩ or higher


If the result is not as specified, replace the telltale light assembly (lane departure alert switch).