CUSTOMIZE POWER BACK DOOR SYSTEM
The following items can be customized.
When the customer requests a change in a function, first make sure that the function can be customized.
Record the current settings before customizing.
Customizing with the Techstream.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Customize Setting / PSD & PBD operation.
Select the setting by referring to the table below.
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| PBD SW Operation | 0.8s | Function that turns the back door control switch on when a switch is pushed once or held down for 0.8 seconds. | 0:0.0s,1:0.8s | Multiplex network door ECU |
| Door Unlock with 1 Motion. | ALL DOORS | Function that selects the door or doors to unlock when the back door is locked and the transmitter switch is pushed to operate the power back door. | 0:BackDoor,1:ALL DOORS | Multiplex network door ECU |
| One Motion | 0.8s | Function that operates the power back door by pushing the transmitter switch when the back door is locked or unlocked. | 0000:OFF,0001:1 Op,0010:2 Op,0011:0.8s,1010:Not Use,1011:Not Use | Multiplex network door ECU
(w/ Wireless Door Lock Buzzer Answer Back Function) |
| PBD Assist Open Operation | ON | Function that enables or disables the power back door assist open operation. When PBD Assist Open is set to on (enabled) the back door will open automatically when the back door opener switch assembly (opener switch) is operated. | 0:OFF,1:ON | Multiplex network door ECU |
| PBD Assist Close Operation | ON | Function that enables or disables the power back door assist close operation. When PBD Assist Close is set to on (enabled) the back door will open automatically when the back door opener switch assembly (opener switch) is operated. | 0:OFF,1:ON | Multiplex network door ECU |