Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR CONTROL SWITCH
RM30B0U _59 Vehicle Exterior _009875 DOOR / HATCH _0061406 POWER BACK DOOR CONTROL SWITCH G

DOOR / HATCH  POWER BACK DOOR CONTROL SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT BACK DOOR CONTROL SWITCH

a.

Check the operation of the door control switch assembly.

i.
B338150
1.625,1.771 1.938,1.927 0.313,0.156 10 *a
*a Component without harness connected
(Back Door Control Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - 4 Back door control switch not pushed 10 kΩ or higher
1 - 4 Back door control switch pushed Below 1 Ω


If the result is not as specified, replace the back door control switch.



b.
B338151
1.521,2.979 1.677,2.667 false 2.052,3 1.875,2.656 false 1.615,1.906 1.927,2.063 0.313,0.156 10 *a 1.375,3.021 1.771,3.229 0.396,0.208 10 ILL+ 1.979,3.021 2.313,3.219 0.333,0.198 10 ILL-
*a Component without harness connected
(Back Door Control Switch)


Check that the switch illuminates.

i.

Apply battery voltage to the power back door control switch assembly and check that the LED illuminates.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 3 (ILL+)
Battery negative (-) → 2 (ILL-)
LED illuminates


If the result is not as specified, replace the back door control switch.