The clearance warning buzzer sounds to alert the driver. The sounding pattern changes depending on the distance to an obstacle.
Disconnect the G34 No. 1 clearance warning buzzer connector.
Disconnect the G33 clearance warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G33-1 (BBZ) - G34-1 | Always | Below 1 Ω |
| G33-2 (ER) - G34-2 | Always | Below 1 Ω |
| G33-1 (BBZ) - Body ground | Always | 10 kΩ or higher |
| G33-2 (ER) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Temporarily replace the No. 1 clearance warning buzzer with a new or normally functioning one.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>CLEARANCE WARNING BUZZER>REMOVAL
Check that the clearance warning buzzer sounds properly when the Toyota parking assist-sensor system detects an obstacle.
| Proceed to |
|---|
| Buzzer sounds properly |
| Buzzer does not sound properly |
Buzzer sounds properly
Buzzer does not sound properly