Use the following procedure to troubleshoot the rear view monitor system.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage with the ignition switch off.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| Symptom does not occur |
| Symptom occurs |
Symptom does not occur
Symptom occurs
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the audio and visual system (for Radio and Display Type).
| Proceed to |
|---|
| Symptom does not appear |
| Symptom appears |
Symptom does not appear
Symptom appears
Refer to Problem Symptoms Table.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>REAR VIEW MONITOR SYSTEM>PROBLEM SYMPTOMS TABLE
| Proceed to |
|---|
| Fault is not listed in Problem Symptoms Table |
| Fault is listed in Problem Symptoms Table |
Fault is not listed in Problem Symptoms Table
Fault is listed in Problem Symptoms Table
Terminals of ECU.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>REAR VIEW MONITOR SYSTEM>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT