1.INSPECT DIFFERENTIAL SIDE GEAR BACKLASH
Hold the differential case in a vise between aluminum plates.
Do not overtighten the vise.
Place a dial indicator on the tip of the side gear tooth at a right angle.
Hold the pinion gear in the differential case and measure the backlash of the side gear.
0.05 to 0.20 mm (0.00197 to 0.00787 in.)
| Thickness |
|---|
| 1.00 mm (0.0394 in.) |
| 1.10 mm (0.0433 in.) |
| 1.20 mm (0.0472 in.) |
| 1.30 mm (0.0512 in.) |
If the backlash is more than the standard range, select another front No. 1 differential side gear thrust washer.