Home › Drivetrain › U760F AUTOMATIC TRANSMISSION / TRANSAXLE › DIFFERENTIAL CASE
RM30B0U _52 Drivetrain _009030 U760F AUTOMATIC TRANSMISSION / TRANSAXLE _0058589 DIFFERENTIAL CASE G

U760F AUTOMATIC TRANSMISSION / TRANSAXLE  DIFFERENTIAL CASE  INSPECTION  


PROCEDURE

Hide 1.INSPECT DIFFERENTIAL SIDE GEAR BACKLASH

a.
C196823

Hold the differential case in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.

Place a dial indicator on the tip of the side gear tooth at a right angle.


c.

Hold the pinion gear in the differential case and measure the backlash of the side gear.

Standard backlash:

0.05 to 0.15 mm (0.00197 to 0.00590 in.)


Thrust Washer Thickness
Thickness Thickness
1.50 mm (0.0591 in.) 1.75 mm (0.0689 in.)
1.55 mm (0.0610 in.) 1.80 mm (0.0709 in.)
1.60 mm (0.0630 in.) 1.85 mm (0.0728 in.)
1.65 mm (0.0650 in.) 1.90 mm (0.0748 in.)
1.70 mm (0.0669 in.) -

If the backlash is more than the standard range, select another front No. 1 differential side gear thrust washer.