Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH › from 2013.11
RM30B0U _51 Engine / Hybrid System _010069 CRUISE CONTROL _0060913 CRUISE CONTROL MAIN SWITCH G

CRUISE CONTROL  CRUISE CONTROL MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT CRUISE CONTROL MAIN SWITCH

a.

Measure the resistance according to the value(s) in the table below.

B357136
4.813,1.167 5.188,0.833 5.188,0.833 5.438,0.833 false 1.635,0.438 1.885,0.438 1.885,0.438 2.302,0.771 false 1.802,3.271 2.188,2.969 true 3.188,3.271 2.719,2.99 true 2.417,3.26 2.49,3 true 5.479,0.75 5.792,0.906 0.313,0.156 10 false *1 1.948,2.24 2.26,2.396 0.313,0.156 10 false *a 5.479,1.25 5.792,1.406 0.313,0.156 10 false *b 4.479,0.656 4.792,0.813 0.313,0.156 10 false *c 4.813,1.833 5.125,1.99 0.313,0.156 10 false *d 3.792,1.604 4.104,1.76 0.313,0.156 10 false *e 1.469,0.365 1.844,0.552 0.375,0.188 10 false *f 2.292,3.302 2.75,3.5 0.458,0.198 10 false IL+2 3.125,3.302 3.583,3.5 0.458,0.198 10 false ECC 1.625,3.302 2.083,3.5 0.458,0.198 10 false CCS
*1 Cruise Control Switch (ON-OFF button) - -
*a Component without harness connected
(Cruise Control Main Switch)
*b ON-OFF
*c +/RES *d -/SET
*e CANCEL *f Earth Point


Standard Resistance:
Tester Connection Condition Specified Condition
1(ECC) - 4(CCS) Cruise control switch (ON-OFF button) released 1 MΩ or higher
Cruise control switch (ON-OFF button) pushed Below 1.5 Ω
+/RES 235 to 245 Ω
-/SET 617 to 643 Ω
CANCEL 1509 to 1571 Ω


If the result is not as specified, replace the cruise control main switch.


b.

Inspect the illumination operation.

i.

Apply battery voltage to the cruise control main switch connector, and check that the cruise control main switch illuminates.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 2(IL+2)
Battery negative (-) → Earth point
Illuminates


If the result is not as specified, replace the cruise control main switch.