These DTCs are stored when a malfunction occurs in the CAN communication circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0073 | Sending Malfunction (Navigation to APGS) | CAN bus connection error | CAN communication system |
| U0100 | Lost Communication with ECM / PCM "A" | CAN reception error | CAN communication system |
| U0129 | Lost Communication with Brake System Control Module | CAN reception error | CAN communication system |
| U0140 | Lost Communication with Body Control Module | CAN reception error | CAN communication system |
| U0155 | Meter ECU Communication | CAN reception error | CAN communication system |
| U0164 | Air Conditioner ECU Communication | CAN reception error | CAN communication system |
Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Clear the DTCs.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check that no DTCs are output.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING