Home › Engine / Hybrid System › 1AD-FTV ENGINE CONTROL › ECD SYSTEM › 2012.12–2015.10
NM3090E _51 Engine / Hybrid System _008652 1AD-FTV ENGINE CONTROL _0048044 ECD SYSTEM DE DETAILS F

1AD-FTV ENGINE CONTROL  ECD SYSTEM  DETAILS  CAMSHAFT POSITION SENSOR  


CONSTRUCTION


a.

Magneto-Resistance Element (MRE) type camshaft position sensor is used. To detect each camshaft position, a timing rotor that is part of the camshaft is used to generate 3 (3 high output, 3 low output) pulses for every 2 revolutions of the crankshaft.

W110542E01
1.646,0.625 2.052,0.625 2.052,0.625 3.24,1.458 true 5.26,0.656 5.01,0.656 5.01,0.656 3.656,1.594 true 0.438,2.677 1.146,2.927 0.708,0.25 10 G Signal 0.604,0.531 1.75,0.844 1.146,0.313 10 Timing Sprocket 5.323,0.583 6.49,1.135 1.167,0.552 10 Camshaft Position Sensor 0.469,3 1.177,3.25 0.708,0.25 10 60° CA 2.542,2.813 3.25,3.063 0.708,0.25 10 180° CA 0.99,3.167 1.698,3.417 0.708,0.25 10 180° CA 2.51,3.177 3.219,3.427 0.708,0.25 10 180° CA 4.083,3.167 4.792,3.417 0.708,0.25 10 180° CA 5.708,3.167 6.417,3.417 0.708,0.25 10 180° CA 3.188,3.417 3.896,3.667 0.708,0.25 10 720° CA 5.729,2.917 6.438,3.167 0.708,0.25 10 180° CA 4.396,2.802 5.104,3.052 0.708,0.25 10 120° CA 1.26,2.917 1.969,3.167 0.708,0.25 10 120° CA 3.625,2.927 4.333,3.177 0.708,0.25 10 60° CA


b.

The MRE type sensor consists of an MRE, a magnet and a sensor.


c.

The direction of the magnetic field changes due to the profile (protruding and non-protruding portions) of the timing rotor, which passes by the sensor. As a result, the resistance of the MRE changes and the output voltage to the ECM changes to high or low. The ECM detects the crankshaft and camshaft positions based on this output voltage.


d.

The differences between the MRE type sensor and the pick-up coil type sensor used on the conventional models are as follows:

·

The MRE type sensor outputs a constant level of high and low digital signals regardless of the engine speed. Therefore, the MRE type sensor can detect the positions of the crankshaft and camshaft at an early stage of cranking.

·

The pick-up coil type sensor outputs analog signals with levels that change with the engine speed.


MRE Type and Pick-up Coil Type Output Waveform Image Comparison
W102805E04
4.427,2.563 4.427,2.948 true 4.688,1.74 4.792,0.979 4.792,0.979 5.021,0.979 true 0.563,1.083 1.094,1.802 0.531,0.719 10 Engine Speed 3.5,1.01 4.031,1.729 0.531,0.719 10 Engine Speed 0.583,2.563 1.115,3.292 0.531,0.729 10 Sensor Output 3.573,2.271 4.104,3 0.531,0.729 10 Sensor Output 1.771,3.25 2.552,3.635 0.781,0.385 10 MRE Type 4.917,3.313 6.042,3.698 1.125,0.385 10 Pick-up Type 2.531,3.021 3.479,3.385 0.948,0.365 10 Digital Output 6.094,2.573 7.104,3 1.01,0.427 10 Analog Output 4.115,3 5.313,3.333 1.198,0.333 10 No Detection Area 5.073,0.906 6.271,1.24 1.198,0.333 10 No Detection Area