Home › Engine / Hybrid System › 2AD-FTV ENGINE CONTROL › ECD SYSTEM
NM3090E _51 Engine / Hybrid System _008660 2AD-FTV ENGINE CONTROL _0048045 ECD SYSTEM CO CONTROL F

2AD-FTV ENGINE CONTROL  ECD SYSTEM  CONTROL  STARTER CONTROL (CRANKING HOLD FUNCTION)  


FUNCTION


a.

On the models with manual transaxle, once the engine switch is pressed, this function operates the starter until the engine starts, provided that the clutch pedal is depressed.


b.

On the models with automatic transaxle, once the engine switch is pressed, this function operates the starter until the engine starts, provided that the brake pedal is depressed and the shift lever is in P or N. This prevents application of the starter for an inadequate length of time and also prevents the engine from being cranked after it has started.


c.

When the certification ECU detects a start signal, it monitors the engine speed signal (NE) from the ECM and operates the starter continuously until it determines that the engine has started completely.