Home › Engine / Hybrid System › 2AD-FHV ENGINE MECHANICAL › ENGINE UNIT
NM3090E _51 Engine / Hybrid System _008669 2AD-FHV ENGINE MECHANICAL _0048048 ENGINE UNIT DE DETAILS F

2AD-FHV ENGINE MECHANICAL  ENGINE UNIT  DETAILS  CRANKSHAFT AND BEARING  


CONSTRUCTION


a.

A crankshaft made of forged steel, which excels in rigidity and wear resistance, is used.


b.

The crankshaft has 5 journals, 4 crank pins and 8 balance weights.

W100391
1.75,2.083 1.969,2.083 1.969,2.083 2.052,1.635 true 2.5,0.833 2.604,0.26 2.604,0.26 2.792,0.26 true 4.083,0.771 4.26,0.344 4.26,0.344 4.448,0.344 true 5.542,1.677 5.792,2.135 5.792,2.135 5.979,2.135 true 1.583,2.01 1.896,2.208 0.313,0.198 10 *1 2.833,0.177 3.146,0.375 0.313,0.198 10 *b 1.021,1.333 1.333,1.531 0.313,0.198 10 *a 6.021,2.063 6.333,2.26 0.313,0.198 10 *3 4.479,0.26 4.792,0.458 0.313,0.198 10 *2
*1 No. 1 Journal *2 Balance Weight
*3 No. 5 Journal - -
*a Engine Front *b Oil Hole



c.

The crankshaft bearings have been optimized in width to reduce friction.


d.

An oil groove is provided on each crankshaft bearing (upper main bearing). The oil groove is deep at the center and is shallow at the edges to reduce the amount of oil that leaks from the crankshaft bearing. As a result, the size of the oil pump is reduced, minimizing friction.


e.

The lining surface of the crankshaft bearing has been micro-grooved to provide an optimal amount of oil clearance. As a result, cold-engine cranking performance has been improved and engine vibrations have been reduced.

W110540
2.958,0.906 3.083,0.521 3.083,0.521 3.302,0.521 true 1.823,0.49 1.99,0.49 1.99,0.49 2.167,0.969 true 2.917,1.948 3.073,2.365 3.073,2.365 3.25,2.365 true 3.354,0.448 3.667,0.604 0.313,0.156 10 *1 3.302,2.292 3.615,2.448 0.313,0.156 10 *2 1.656,0.406 1.969,0.563 0.313,0.156 10 *a 1.25,1.771 1.563,1.927 0.313,0.156 10 *b 5.031,0.74 5.344,0.896 0.313,0.156 10 *c 3.99,1.438 4.302,1.594 0.313,0.156 10 *d 5.073,1.948 5.385,2.104 0.313,0.156 10 *e 6.031,1.427 6.344,1.583 0.313,0.156 10 *d
*1 Upper Main Bearing *2 Lower Main Bearing
*a Oil Groove *b Micro-grooved
*c Center *d Edge
*e Oil Groove Depth - -