Home › Engine / Hybrid System › 3ZR-FAE ENGINE MECHANICAL › ENGINE UNIT › 2012.12–2015.04
NM3090E _51 Engine / Hybrid System _008645 3ZR-FAE ENGINE MECHANICAL _0048054 ENGINE UNIT GE GENERAL F

3ZR-FAE ENGINE MECHANICAL  ENGINE UNIT  GENERAL  GENERAL  


OUTLINE


a.

The 3ZR-FAE engine is an in-line 4-cylinder, 2.0-liter, 16-valve DOHC engine. This engine uses the VALVEMATIC, Dual Variable Valve Timing-intelligent (Dual VVT-i) system, Acoustic Control Induction System (ACIS), Direct Ignition System (DIS) and Electronic Throttle Control System-intelligent (ETCS-i). They have been developed to achieve high performance and fuel economy, and to reduce exhaust emissions.



SPECIFICATION


No. of Cyls. and Arrangement 4-cylinder, In-line
Valve Mechanism 16-valve DOHC, Chain Drive
(with VALVEMATIC and Dual VVT-i)
Combustion Chamber Pentroof Type
Manifolds Cross-flow
Fuel System Sequential Multiport Fuel Injection (SFI)
Ignition System Direct Ignition System (DIS)
Displacement 1987 cm3 (121.3 cu. in.)
Bore x Stroke 80.5 mm x 97.6 mm (3.17 in. x 3.84 in.)
Compression Ratio 10.0 : 1
Max. Output (SAE-NET) 111 kW @ 6200 rpm
Max. Torque (SAE-NET) 195 N*m @ 4000 rpm
Valve Timing Intake Open 15° to -14° BTDC
Closed 70° to -60° ABDC
Exhaust Open 65° to 25° BBDC
Closed 1° to 39° ATDC
Spark Plug Manufacture DENSO
Type SC20HR11
Plug Gap 1.0 mm to 1.1 mm (0.039 in. to 0.043 in.)
Firing Order 1 - 3 - 4 - 2
Research Octane Number 95 or higher*2
Emission Regulation EURO 5*3
EURO 4*4
Engine Service Mass (Reference)*1 147 kg (324.0 lb)

*1: Weight shows the figure with oil and engine coolant fully filled.

*2: Premium unleaded gasoline with a research octane number 95 or higher required for optimum engine performance. If 95 octane cannot be obtained, you may use unleaded gasoline with a research octane number as low as 91. Use of unleaded fuel with a research octane number lower than 95 may result in engine knocking and significantly reduced performance. Persistent knocking can lead to engine damage and should be corrected by refueling with higher octane unleaded gasoline.

*3: Except models for Singapore

*4: Models for Singapore


W111604
0.635,1.573 1.51,1.917 0.875,0.344 10 Torque (N*m) 5.51,1.885 6.344,2.25 0.833,0.365 10 Output (kW) 2.948,4.49 4.26,4.792 1.313,0.302 10 Engine Speed (rpm) 1.708,2.063 2,2.323 0.292,0.26 10 150 1.708,1.875 2,2.135 0.292,0.26 10 160 1.708,1.698 2,1.958 0.292,0.26 10 170 1.708,1.51 2,1.771 0.292,0.26 10 180 1.708,1.333 2,1.594 0.292,0.26 10 190 1.708,1.167 2,1.427 0.292,0.26 10 200 5.177,0.573 5.469,0.833 0.292,0.26 10 120 5.177,1.115 5.469,1.375 0.292,0.26 10 100 5.177,1.656 5.469,1.917 0.292,0.26 10 80 5.177,2.229 5.469,2.49 0.292,0.26 10 60 5.177,2.792 5.469,3.052 0.292,0.26 10 40 5.177,3.323 5.469,3.583 0.292,0.26 10 20 5.177,3.896 5.469,4.156 0.292,0.26 10 0 2.188,4.156 2.479,4.417 0.292,0.26 10 0 2.438,4.156 2.771,4.417 0.333,0.26 10 1000 2.823,4.156 3.156,4.417 0.333,0.26 10 2000 3.208,4.156 3.542,4.417 0.333,0.26 10 3000 3.583,4.156 3.917,4.417 0.333,0.26 10 4000 3.958,4.156 4.292,4.417 0.333,0.26 10 5000 4.333,4.156 4.667,4.417 0.333,0.26 10 6000 4.719,4.156 5.052,4.417 0.333,0.26 10 7000


MAIN FEATURES


a.

The following performance features have been achieved for the 3ZR-FAE engine through the use of the items listed below:

i.

High performance and reliability


ii.

Low noise and vibration


iii.

Lightweight and compact design


iv.

Good serviceability


v.

Clean emissions and fuel economy

Item (1) (2) (3) (4) (5)
Engine Proper A cylinder block made of aluminum alloy is used. - - ○ - -
Spiny liners are used. ○ - - - -
The skirt portion of the piston has a resin coating applied to reduce friction. ○ ○ - - ○
Low tension piston rings are used. ○ - - - ○
Valve Mechanism A timing chain and a chain tensioner are used. - ○ - ○ -
Valve lash adjuster assemblies are used. - ○ - ○ -
Valve rocker arm sub-assemblies are used. ○ ○ - ○ -
The Dual Variable Valve Timing- intelligent (Dual VVT-i) system is used. ○ - - - ○
Cooling System Toyota Genuine Super Long Life Coolant (SLLC) is used. - - - ○ -
Intake and Exhaust System An intake manifold made of plastic is used. - - ○ - -
A stainless steel exhaust manifold is used. - - ○ - ○
Three-Way Catalysts (TWCs) are used. - - - - ○
Fuel System A fuel returnless system is used. - - ○ ○ ○
Quick connectors are used to connect the fuel hose with the fuel pipe. - - - ○ -
Serpentine Belt Drive System A serpentine belt drive system is used. ○ - ○ ○ -
Engine Control System A Magnetic Resistance Element (MRE) type camshaft position sensor is used. - - - - ○
The Direct Ignition System (DIS) makes ignition timing adjustment unnecessary. ○ - - ○ ○
The Electronic Throttle Control System-intelligent (ETCS-i) is used. ○ - - - -
The Dual Variable Valve Timing- intelligent (Dual VVT-i) is used. ○ - - - ○
The starter control is used.* ○ - - - -
The VALVEMATIC is used. ○ - - - ○
The Acoustic Control Induction System (ACIS) is used. ○ - - - ○

*: Models with entry and start system


HINT:

○: Applicable

-: Not applicable