Home › Power Source / Network › 2AD-FTV BATTERY / CHARGING › CHARGING SYSTEM
NM3090E _57 Power Source / Network _009050 2AD-FTV BATTERY / CHARGING _0049500 CHARGING SYSTEM CO CONTROL F

2AD-FTV BATTERY / CHARGING  CHARGING SYSTEM  CONTROL  CHARGING CONTROL  


SYSTEM CONTROL


a.

This system lowers the generated voltage when the vehicle is not decelerating, and raises the generated voltage when the vehicle is decelerating. This reduces the load on the engine as a result of the electric generation of the generator, thus contributing to the fuel economy of the engine. When idling or driving at a constant speed, this system regulates the generated voltage in order to place the current integrated value close to the target value.


b.

This control consists of a battery current sensor, battery temperature sensor, generator assembly, ECM, various sensors and switches.


c.

The ECM stops the charging control and the generator switches to the constant voltage power generation mode under the following conditions:

i.

Low battery capacity


ii.

Low or high battery temperature


iii.

Wipers operating or blower motor operating over high load or tail light relay ON


iv.

Battery current sensor or battery temperature sensor malfunction


v.

Battery capacity check auxiliary charging being performed after starting engine