FUNCTION OF MAIN COMPONENTS
| Component | Function |
|---|---|
| Combination Meter Assembly | The hazard warning light is made to blink in accordance with the operation signal of the emergency brake signal from the skid control ECU. |
| Skid Control ECU | Manages signals from each sensor and sends the operation signal of the emergency brake signal to the combination meter assembly. |
| Stop Light Switch Assembly | Detects the brake pedal depressing signal. |
SYSTEM CONTROL
Operating Condition
The activating and deactivating conditions for the emergency brake signal are as shown in the following table:
| Condition | Details |
|---|---|
| Emergency Brake Signal Operating Conditions | When all of the following conditions are met, the emergency brake signal starts operating:
·
Vehicle speed is above 55 km/h (35 mph). ·
Driver is depressing the brake pedal. ·
Emergency braking is detected from the vehicle deceleration. |
| Emergency Brake Signal Ending Conditions | When any of the following conditions is met, the emergency brake signal stops operating:
·
Driver has released the brake pedal. ·
Emergency braking is no longer detected from the vehicle deceleration. ·
Driver has pressed the hazard warning signal switch. |