Home › Engine / Hybrid System › 2WW ENGINE CONTROL › ECD SYSTEM › from 2015.10
NM3090E _51 Engine / Hybrid System _043813 2WW ENGINE CONTROL _0205037 ECD SYSTEM DE DETAILS F

2WW ENGINE CONTROL  ECD SYSTEM  DETAILS  CRANKSHAFT POSITION SENSOR  


CONSTRUCTION


a.

A Hall IC type crankshaft position sensor is used.


b.

The multi-pole sensor wheel has 58 magnetic pole pairs and a reference point. The reference point is a magnetic pole pair that is two times longer than the other magnetic pole pairs. TDC is detected using this reference point.

W112454C02
1.771,0.594 2.26,0.781 true 4.885,1.573 5.521,1.385 true 4.583,0.625 4.521,0.281 true 4.448,0.656 4.229,0.417 true 3.688,2.51 3.281,2.583 true 3.771,2.844 3.365,2.917 true 1.563,0.479 1.771,0.656 0.208,0.177 10 false *1 5.563,1.313 5.74,1.479 0.177,0.167 10 false *2 4.063,0.25 4.26,0.427 0.198,0.177 10 false *a 3.177,2.865 3.365,3.021 0.188,0.156 10 false *b 4.417,0.104 4.615,0.281 0.198,0.177 10 false *a 3.094,2.531 3.302,2.698 0.208,0.167 10 false *b
*1 Crankshaft Position Sensor *2 Multi-pole Sensor Wheel
*a Magnetic Pole Pair *b Reference Point



c.

The transition from a high to a low phase is signaled by a change in the magnetic field. The difference between 2 changes of the magnetic field is 6° crankshaft angle.

W112455C02
4.646,3.573 4.115,2.5 true 0.448,0.813 0.646,1 0.198,0.188 10 false *a 0.479,2.417 0.677,2.583 0.198,0.167 10 false *b 4.677,3.563 4.865,3.74 0.188,0.177 10 false *c
*a Multi-pole Sensor Wheel *b Signal Shape (Calculated Internally)
*c Reference Signal - -