Home › Engine / Hybrid System › 3ZR-FE ENGINE MECHANICAL › ENGINE UNIT › from 2015.10
NM3090E _51 Engine / Hybrid System _008637 3ZR-FE ENGINE MECHANICAL _0048055 ENGINE UNIT GE GENERAL F

3ZR-FE ENGINE MECHANICAL  ENGINE UNIT  GENERAL  GENERAL  


OUTLINE


a.

The 3ZR-FE engine is an in-line 4-cylinder, 2.0-liter, 16-valve DOHC engine. This engine uses the Dual Variable Valve Timing-intelligent (Dual VVT-i) system, Acoustic Control Induction System (ACIS), Direct Ignition System (DIS) and Electronic Throttle Control System-intelligent (ETCS-i). These systems have been developed to realize high performance and fuel economy, and reduce exhaust emissions.



SPECIFICATION


No. of Cyls. and Arrangement 4-cylinder, In-line
Valve Mechanism 16-valve DOHC, Chain Drive
(with Dual VVT-i)
Combustion Chamber Pentroof Type
Manifolds Cross-flow
Fuel System Sequential Multiport Fuel Injection (SFI)
Ignition System Direct Ignition System (DIS)
Displacement 1987 cm3 (121.3 cu. in.)
Bore x Stroke 80.5 mm x 97.6 mm (3.17 in. x 3.84 in.)
Compression Ratio 10.0 : 1
Max. Output (SAE-NET) 107 kW @ 6200 rpm
Max. Torque (SAE-NET) 187 N*m @ 3700 to 3900 rpm
Valve Timing Intake Open 1° to 44° BTDC
Closed 65° to 22° ABDC
Exhaust Open 51° to 11° BBDC
Closed 3° to 43° ATDC
Spark Plug Manufacture DENSO
Type SC16HR11 or SC20HR11
Plug Gap 1.0 mm to 1.1 mm (0.039 in. to 0.043 in.)
Firing Order 1 - 3 - 4 - 2
Research Octane Number 91 (Octane Rating 87) or higher
Emission Regulation*1 EURO 5
EURO 4
BRLEV
Engine Service Mass (Reference)*2 109.8 kg (242.1 lb)

*1: Emission regulation differ by country and region.

*2: Weight shows the figure with oil and engine coolant fully filled.


HINT:

Toyota allows the use of ethanol blended gasoline where the ethanol content is up to 10%. Make sure that the ethanol blended gasoline to be used has a Research Octane Number that follows the above.



MAIN FEATURES


a.

The following performance features have been achieved for the 3ZR-FE engine through the use of the items listed below:

i.

High performance and reliability


ii.

Low noise and vibration


iii.

Lightweight and compact design


iv.

Good serviceability


v.

Clean emissions and fuel economy

Item (1) (2) (3) (4) (5)
Engine Proper A cylinder block made of aluminum alloy is used. - - ○ - -
Spiny liners are used. ○ - - - -
The skirt portion of the piston has a resin coating applied to reduce friction. ○ ○ - - ○
Low tension piston rings are used. ○ - - - ○
Valve Mechanism A timing chain and a chain tensioner are used. - ○ - ○ -
Valve lash adjuster assemblies are used. - ○ - ○ -
Valve rocker arm sub-assemblies are used. ○ ○ - ○ -
The Dual Variable Valve Timing- intelligent (Dual VVT-i) system is used. ○ - - - ○
Cooling System Toyota Genuine Super Long Life Coolant (SLLC) is used. - - - ○ -
Intake and Exhaust System An intake manifold made of plastic is used. - - ○ - -
A stainless steel exhaust manifold is used. - - ○ - ○
Three-Way Catalysts (TWCs) are used. - - - - ○
Fuel System A fuel returnless system is used. - - ○ ○ ○
Quick connectors are used to connect the fuel hose with the fuel pipe. - - - ○ -
Serpentine Belt Drive System A serpentine belt drive system is used. ○ - ○ ○ -
Engine Control System A Magnetic Resistance Element (MRE) type camshaft position sensor is used. - - - - ○
The Direct Ignition System (DIS) makes ignition timing adjustment unnecessary. ○ - - ○ ○
The Electronic Throttle Control System-intelligent (ETCS-i) is used. ○ - - - -
The Dual Variable Valve Timing- intelligent (Dual VVT-i) is used. ○ - - - ○
The starter control is used.* ○ - - - -
The Acoustic Control Induction System (ACIS) is used. ○ - - - ○

*: Models with entry and start system


HINT:

○: Applicable

-: Not applicable