Home › Engine / Hybrid System › 3ZR-FE ENGINE CONTROL › SFI SYSTEM › from 2015.10
NM3090E _51 Engine / Hybrid System _008636 3ZR-FE ENGINE CONTROL _0048052 SFI SYSTEM DE DETAILS F

3ZR-FE ENGINE CONTROL  SFI SYSTEM  DETAILS  STARTER CONTROL (CRANKING HOLD FUNCTION)  


OPERATION


a.

When the driver pushes the engine switch once and the certification ECU (smart key ECU assembly) detects a start signal, the certification ECU (smart key ECU assembly) outputs ACCD and STAR signals and begins cranking. Also, the driver can continue cranking for up to 30 seconds by pushing and holding the engine switch.


b.

If the engine speed reaches approximately 500 rpm, the ECM will judge that the engine has started and will send a signal to the certification ECU (smart key ECU assembly) using CAN communication. The certification ECU (smart key ECU assembly) will then stop the operation of the starter.


c.

If CAN communication is cut between the certification ECU (smart key ECU assembly) and the ECM, the certification ECU (smart key ECU assembly) will receive an engine speed signal (NE) directly from the ECM and will stop the operation of the starter.


d.

This system cuts off the power current which activates the accessories while the engine is being cranked. This prevents the intermittent blinking of the accessory lights caused by the voltage instability that occurs during engine cranking.


e.

This system has the following protections:

·

The starter does not operate when the engine is operating normally.

·

If the engine switch is pushed and held, cranking will stop once the engine speed reaches a pre-determined level. This prevents the starter from over-revving.

·

If the engine does not start even after approximately 6 seconds of starter operation, the certification ECU (smart key ECU assembly) will cancel the starter relay output. Furthermore, if the engine does not start after the engine switch has been pushed and held and cranking has continued for 30 seconds, cranking will be canceled in order to protect the starter.

·

It will not be possible to operate the starter for 2 seconds after engine starting has failed and cranking has been canceled. This helps to protect the starter.


W100462E27
0.635,1.5 1.583,1.813 0.948,0.313 10 false Engine Switch 3.323,1.438 3.719,1.802 0.396,0.365 10 false ECM 4.146,1.281 5.177,1.938 1.031,0.656 10 false CAN (Bus 2)*3, CAN (V Bus)*4 1.99,3.219 2.729,3.552 0.74,0.333 10 false ACC Relay 4.5,5.073 5.125,6.094 0.625,1.021 10 false Starter Relay Assembly 1.49,5.146 2.615,5.531 1.125,0.385 10 false Starter Assembly 5.625,0.698 6.021,1.063 0.396,0.365 10 false SSW 5.708,3.333 6.875,4.521 1.167,1.188 10 false Certification ECU (Smart Key ECU Assembly) 5.615,1.99 6.01,2.354 0.396,0.365 10 false NE 5.604,2.469 6.229,2.76 0.625,0.292 10 false ACCD 5.615,2.771 6.24,3.135 0.625,0.365 10 false STAR 5.635,4.875 5.958,5.208 0.323,0.333 10 false STA 5.604,5.552 5.927,5.813 0.323,0.26 10 false STP 4.688,6.167 6.021,6.5 1.333,0.333 10 false Stop Light Signal 4.542,2.927 5.521,4.927 0.979,2 10 false Clutch Start Switch Assembly*1 or Park/Neutral Position Switch Assembly*2 0.156,5.667 3.729,6.021 3.573,0.354 10 false *2: Models with Continuously Variable Transaxle (CVT) 0.146,5.375 2.344,5.698 2.198,0.323 10 false *1: Models with manual transaxle 0.156,5.958 3.729,6.313 3.573,0.354 10 false *3: Models with central gateway ECU 0.156,6.229 3.729,6.583 3.573,0.354 10 false *4: Models without central gateway ECU

W102484E02
1.948,0.25 2.229,0.521 0.281,0.271 10 On 1.948,1.198 2.24,1.469 0.292,0.271 10 On 1.948,2.0 2.26,2.271 0.313,0.271 10 On 1.948,1.604 2.24,1.875 0.292,0.271 10 Off 1.958,0.677 2.24,0.948 0.281,0.271 10 Off 1.938,2.396 2.25,2.667 0.313,0.271 10 Off 0.479,0.427 1.385,0.813 0.906,0.385 10 Starter Signal 0.479,2.146 1.625,2.635 1.146,0.49 10 Accessory Power 0.49,1.396 1.396,1.781 0.906,0.385 10 Starter Relay 0.323,3.073 1.979,3.448 1.656,0.375 10 Engine Speed Signal (NE) 1.688,3.938 5.292,4.604 3.604,0.667 10 ECM determines that the engine has started successfully when the engine speed is approximately 500 rpm. 5.573,2.521 6.844,3.188 1.271,0.667 10 Successful Starting of Engine 5.594,3.229 6.573,3.896 0.979,0.667 10 Failed Starting of Engine