FUNCTION OF MAIN COMPONENTS
| Component | Function | |
|---|---|---|
| Forward Recognition Camera | The forward recognition camera determines when to turn the high beams on and off after identifying the lights of oncoming vehicles, preceding vehicles and other lights from the picture information of its camera. | |
| Center Airbag Sensor Assembly | Detects the yaw rate of the vehicle and transmits the signal to the forward recognition camera. | |
| Skid Control ECU | Transmits the speed sensor signal to the forward recognition camera. | |
| ECM | Transmits the shift position signal to the forward recognition camera. | |
| Combination Meter Assembly | Automatic High Beam Indicator Light | The automatic high beam indicator light illuminates (green) to inform the driver when the Automatic High Beam (AHB) system is activated. |
| Multi-information Display | The automatic warning message is displayed to inform the driver when a malfunction is detected in this system. | |
| Headlight High Beam Indicator Light | The headlight high beam indicator light illuminates (blue) to inform the driver when the high beam headlights are on. | |
| Main Body ECU (Multiplex Network Body ECU) | ·
The main body ECU receives the signals from the headlight dimmer switch assembly and the automatic light control sensor. ·
The main body ECU operates the high beams based on request signals that are received from the forward recognition camera. ·
The main body ECU transmits the signals to the combination meter assembly. |
|
| Headlight Dimmer Switch Assembly | Light Control Switch | The light control switch transmits the auto position signal and the high beam position signal to the main body ECU. |
| Driving Support ECU Assembly | Transmits the forward recognition camera signal to the main body ECU. | |
SYSTEM CONTROL
The Automatic High Beam (AHB) system operates as follows:
| Condition | Details |
|---|---|
| System Activation | When all of the following conditions are met, the AHB system is activated and the automatic high beam indicator light turns on:
·
The ignition switch is ON. ·
The headlight dimmer switch assembly (light control switch) is in the AUTO position and high beam position. ·
The automatic light control sensor outputs the night mode signal (to turn the headlights on). |
| High Beam Headlight On | When all of the following conditions are met, the AHB system turns on the high beam headlights after a short delay:
·
Vehicle speed is more than approximately 30 km/h (19 mph). ·
The area in front of the vehicle is dark. ·
No oncoming vehicles are present with the headlights on. ·
No preceding vehicles are present with the taillights on. ·
Few streetlights are present along the street ahead. |
| High Beam Headlight Off | When any of the following conditions are met, the automatic system turns off the high beam headlights after a short delay:
·
Vehicle speed is less than approximately 25 km/h (16 mph). ·
The area in front of the vehicle is not dark. ·
An oncoming vehicle with headlights on is detected. ·
A preceding vehicle with taillights on is detected. ·
Several street lights are present along the street ahead. |
FUNCTION
When passing an oncoming vehicle
The Automatic High Beam (AHB) system turns the high beam headlights off when there is an oncoming vehicle before its distance reaches approximately 800 m (2625 ft.).
When an oncoming vehicle passes the forward recognition camera range, the AHB system turns the high beam headlights on after a short delay.
| *a | Approx. 800 m (2625 ft.) | *b | Delay |
| *c | Camera Angle | - | - |
When passing a preceding vehicle
The AHB system turns the high beam headlights off when there is a preceding vehicle before its distance reaches approximately 600 m (1969 ft.).
When a preceding vehicle passes the forward recognition camera range, the AHB system turns the high beam headlights on after a short delay.
| *a | Approx. 600 m (1969 ft.) | *b | Delay |
| *c | Camera Angle | - | - |