Home › Engine / Hybrid System › 2WW STOP AND START › STOP AND START SYSTEM › from 2015.10
NM3090E _51 Engine / Hybrid System _047482 2WW STOP AND START _0224616 STOP AND START SYSTEM DE DETAILS F

2WW STOP AND START  STOP AND START SYSTEM  DETAILS  COMBINATION METER  


CONSTRUCTION


a.

The combination meter assembly receives the idling on/off signals from the engine stop and start ECU.


b.

By operating the steering pad switch assembly, the display mode can be changed. One display mode shows the current idling stop time, the idling stop time since the ignition switch was turned ON and the total idling stop time since the last time the idling stop time was reset. The other display mode shows the current idling stop time, the fuel consumption amount since the ignition switch was turned ON and the total fuel consumption amount since the last time the idling stop time was reset.


c.

When the engine cannot be stopped by the stop and start system or when the engine automatically restarts while the engine is stopped by the stop and start system, the messages are displayed on the multi-information display.


d.

The driver is informed of the system operation status and warnings by the illumination of the stop and start indicator light, the illumination and flashing of the stop and start cancel indicator light, the display of items on the multi-information display and the sounding of the multi buzzer.

Y181644C01
2.24,1.792 1.844,0.635 true 2.052,1.844 1.146,1.354 true 3.594,3.281 3.583,2.688 true 1.729,0.448 2.042,0.604 0.313,0.156 10 false *1 0.979,1.219 1.292,1.375 0.313,0.156 10 false *2 3.51,3.281 3.823,3.438 0.313,0.156 10 false *3
*1 Stop and Start Indicator Light *2 Stop and Start Cancel Indicator Light
*3 Multi-information Display - -


Stop and Start Indicator Light Operation
Item Condition Stop and Start Indicator Light Buzzer

*: The blinking interval is 0.15 seconds.

System Operating (Engine is stopped) The vehicle is operating normally. Illuminates Does not sound
The shift lever is operated without depressing the clutch pedal. Blinks* Sounds

Stop and Start Cancel Indicator Light Operation
Condition Stop and Start Cancel Indicator Light

*: The blinking interval is 0.5 seconds.

The vehicle is stopped and system operation conditions are met. OFF
When the stop and start system cancel switch (ecorun cancel switch assembly) is ON. Illuminates
When any Diagnostic Trouble Codes (DTCs) are detected. Blinks*
When the number of times the starter assembly has been operated exceeds the threshold.

Multi-information Display Operation
Condition Cause Multi-information Display
System Malfunction Display A system malfunction is detected. Stop & Start System Malfunction
Visit Your Dealer
Display of Temporary Cancellation of Idling Stop Operation The user decides to give priority to air conditioning control during an idling stop. For climate control
The negative pressure of the brakes becomes insufficient during an idling stop. For brake system
The battery charge amount decreases during an idling stop. Battery charging
The steering wheel is turned by a certain amount or more during an idling stop. Steering wheel turned
The driver's seat belt is unfastened during an idling stop. Driver seat belt unbuckled
Display of Prohibition Status of Stop and Start Control Priority is being given to air conditioning control. For climate control
The battery charge amount decreases to the point that the engine cannot be stopped. Battery charging
The negative pressure of the brakes is insufficient. For brake system
The driver's seat belt is not fastened. Driver seat belt unbuckled
A battery not matching the vehicle specifications is used, causing the battery voltage to fall below the minimum starting voltage. Non-Dedicated Battery